Get Only US $139.00 Window Cleaner Robot Auto Window Cleaner Anti-Falling Smart Window Glass Cleaner Robot Vacuum Clean

Window Cleaner Robot Auto Window Cleaner Anti-Falling Smart Window Glass Cleaner Robot Vacuum Clean

[32853173938] Real picture from buyer's Feedback: (Shipped From Russia) Big Discount Wet And Dry Window Cleaner Robot Automatic Glass Cleaning With Remote Control What’s the window cleaning robot? Glass-cleaning robot, with a vacuum motor inside that can suck air and stand on the glass surface. It also can clean the table, floor, wall, door, ceiling and all flat surface. Getting to know the device: Window Cleaning Robot shall always connect power cable for normalusing. How to put device onto glass to start using 1. Turn on power-switch, and then make sure the fan is running. 2. Put device onto glass. 3. Check if device can stick to the glass before releasing it. How to take device down from glass 1. While device is running, please hold safety rope with one hand and take devicedown from glass with the other hand. 2. Turn off power-switch in safe area. Safety rope and buckle 1. Before using, check if the safety rope is broken or the knot is loose. 2. Fasten the safety rope and tie to indoor fixture before operating. Remote control The device can be remote controlfrom the front and backside. Read all instructions before operating the deviceWARNING: 1. Fasten the safety rope and tie to indoor fixture before operating the device. 2. Check if the safety rope is broken or the knot is loose before operating the device. 3. Set danger-warning area downstairs for no-balcony window and door. 4. Battery shall be full-charged (green lamp ON) before using. 5. Do not use it in rainy or moist day. 6. Turn power on before put device onto glass. 7. Make sure appliance can stick and stand on glass surface while put onto glass. 8. Before turn power off, please hold device. 9. Make sure put cleaning ring onto cleaning wheel correctly for no leakage. 11. Do not spray or pour water onto the appliance. 12. Prohibit children from using this device. 13. Remove anything on the glass. Do not use on cracked glass. Reflective or coating glass might be slightly scratched due to dirt on the glass while operating. 14. Keep hair, loose clothing, fingers, and all parts of body away from the openings and moving parts. 15. Do no use in areas with existed flammable or combustible liquids, gas. Frequently asked questions (FAQ) Q1: when start the machine, hear the alarm sounds, the red light flashing on the back. The solution: (1) check whether the plug and socket have connected to electricity, please maintain switch socket normal power supply. (2) check whether it is caused by a transformer or the power cord damage, in this case, you need to change the new matching transformers or power supply cord. Q2: If Robot can’t start-up and alert at the beginning of self-test. The solution: It means that the friction factor is not properly used. Please check: (1) Whether the cleaning cloth is too dirty. (2) Glass stickers, window film on the glass will also affect the friction factor. (3) If clean window many times, the glass surface will become very slippery. (4) The glass surface will become slippery if clean several times in low humidity environment such as in air-conditioned room. Q3: Robot slips and cannot get higher to the window frame. The solution: (1) Friction factor is too low that might be caused by glass stickers, window film on the glass. (2) Cleaning cloth might be too wet. (3) If clean window many times, the glass surface will become very slippery. (4) The glass surface will become slippery if clean several times in low humidity environment such as in air-conditioned room. Q4: Robot does not move smoothly or move irregularly. The solution: (1) Glass surface has different friction factor areas due to stickers, window film, and so on. Please use Robot in single area. (2) The screw of cleaning wheel might be get loose, just tighten it. Q5: Send out alarming infirst running process, red lamp flashing. The solution: (1) Cleaning cloth is too dirty, Please change a clean-cleaning cloth. (2) Please Check the cleaning cloth is installed correctly. Q6: What to do if Robot stopped at higher area while no electric power supplied, Robot alarmand red lamp is flashing? The solution: (1) User can pull Robot back with safety rope. Slightly pull the safety rope atan angle close to the glass to prevent dropping. (2) Switch the power-switch to “off”. (3) Check out whether electric poor-contact, cable broken or not. Q7: What to do if Robot abnormally stopped and red lamp is flashing, without alarm? The solution: (1) User can move Robot to safe area by remote control, or pull robot back with safety rope. Slightly pull the safety rope at an angle close to the glass to prevent dropping. (2) Switch the power-switch to “off” (3) Check out whether electric poor-contact, cable broken or not. (4) Check whether there is air-leakage caused by gap, uneven window frame. Q8: After cleaning, remained circle mark on the glass surface. The solution: Cleaning cloth is too dirty. Please change a clean-cleaning cloth and clean again. Packing list: Ø Device x 1 Ø Remote controller x 1 Ø Adapter (100~240VAC, 50~60Hz) x 1 Ø AC power cord x 1 Ø DC power extension cable (4 meter) x 1 Ø Cleaning cloth x 12 Ø Cleaning ring x 4 Ø User manual x 1 Kindnote： 1)NowalltherobotwillcomewiththeEnglishPackingwiththeEnglishManual. 2)AboutthePackingandlogo,theremaycomewith"DEVVIS"brand OR without logo etc...,theyareTHESAMEproduct,hopeyoucanaccpetitbeforeyoubuy. AboutShippment: 1.Shipping From Russia Warehouse,we will use the Pony Express or Russia post or IML ETC.. depends on actual situation. Please confirm thatyou can accept it before you buy. 2.Shipping to other countries: will use TNT OR FEDEX OR China Post Air Mail, but sometimes ,we may make shipment by DHL,UPS OR Aramex etc, according to the actual situation.So hope you can accept this. 3. About in importing tax,Every buyer must cooperate to take responsibility of customs clearance and customs duties, If the goods was returned becuase buyer issue ,that buyer should take in charge all the cost,thanks Payment: We support the following payment methods. All payments made on AliExpress are processed by Alipay. Warranty and Terms: All our goods (unless otherwise specified) are assured to be brand new and carried with fully at least One year warranty. During warranty Time, if any problem happens due to quality reason,please be cooperative to take photos orvideos on theproblem and send to us for verifying by email. For confirmed product faulty on your approval, we can send you free spare parts for replacement . Feedback policy: *We will provide positive feedback once payment is received,To foster a healthy Ali community,we hope you will do the same for us.We want you to understand that we value customer service tremendously.If you have any dissatisfaction,please give us the opportunity to resolve the problem before leave us a negative feedback.We are sure that there is always solution and we sure don`t want a bad feedback to be where the transaction ends. Notes: *Mix order welcome,OEM order welcome. *If you have any question please feel free to contact us. We will reply within 24hours